The Ohlins DMX0308 TTX Flow DV is a rear shock for KTM enduro models including the 300 EXC range and 450/500 EXC-F variants listed. Built around Ohlins TTX architecture, it is intended to deliver consistent damping feel and clear chassis feedback across changing terrain. The spring is supplied separately, allowing the correct rate to be selected for the rider and use.

Ohlins | Made to race, perfected to ride

TTX Flow DV technology is derived from Ohlins competition development, with a focus on controlled damping behaviour and predictable traction. This unit is designed for off-road conditions where suspension temperature and repeated impacts can challenge consistency.

Shock design & features

  • Rear mono shock layout for the listed KTM models
  • Oil/gas separated, gas-pressurised design to help maintain damping consistency as conditions change
  • Ohlins TTX Flow DV internal architecture for stable, controlled damping response

Tuning controls

  • Compression damping adjustment
  • Rebound damping adjustment
  • Spring preload adjustment (note: a preload adjuster accessory is referenced in the product notes)

Before you install

  • Spring is sold separately; confirm the correct spring selection before installation
  • Check the product notes regarding preload adjuster compatibility
  • This part number is noted as replaced by DMX 1308; confirm the required part number for your bike and year before ordering

Serviceability/lifecycle

As a serviceable Ohlins shock, routine maintenance and oil changes are part of keeping damping performance consistent over time. Use the recommended Ohlins suspension fluid where specified for this model.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX0308
Model # T46PR1C2Q1W
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 403.0
Type Code T46PR1C2Q1W
Stroke Metal to Metal (mm) 93.0
Product Family TTX Flow DV
Notes Preload adjuster 15000-03 fits this shock *Replaced by DMX 1308*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category