The Ohlins DU008 is a rear STX 46 Mono shock developed for the Ducati 900 SS, aimed at improving damping control and chassis stability. Built from proven racing concepts, it is intended to deliver consistent feel and predictable behaviour as conditions change. It suits riders who want clearer feedback and a more controlled rear end.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered to provide stable, repeatable damping behaviour and strong tyre contact. On the road or track, the focus is on control, grip and confidence through corners and under braking.

Who this shock is for

This rear shock is designed for Ducati 900 SS owners looking for more support and consistency than a basic rear unit can offer. It suits spirited road riding and track use where traction and stability on corner exit matter.

Shock design & features

The DU008 is a gas-pressurised rear shock from the STX 46 mono shock family. The gas-pressurised design is intended to help reduce fade and maintain damping consistency during repeated hard use, with valving developed from race experience to support predictable handling.

Tuning controls

This unit provides adjustable damping with independent compression and rebound circuits, allowing you to tailor response for grip, comfort and stability. These adjustments help refine behaviour under acceleration, cornering and braking to suit tyre choice and riding conditions.

Before you install

  • Confirm fitment for your Ducati 900 SS and check mounting condition before installation.
  • After fitting, set sag and then fine-tune compression and rebound adjustments to match your load and riding style.
  • If any other worn chassis components are present (linkage bearings, bushes or mounts), address them to get the best result from the shock.

Serviceability/lifecycle

Ohlins shocks are designed to be maintained and serviced so performance can be restored over time. Routine servicing helps preserve damping consistency and the intended ride quality, especially if the bike sees frequent hard use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU008
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 345.0 +5/-7
Spring Rate Standard 85.0 N/mm
Type Code S46PCR
Stroke Metal to Metal (mm) 59.0
Product Family STX46 Street
Fitted Spring 01096-26

More From This Category