The Ohlins STX 36 scooter rear shock pair for the Honda ST125 Dax is built to improve damping control and chassis stability in real road conditions. The design uses a pressurised, separated oil/gas layout to help maintain consistent performance through temperature and workload changes. It’s intended for riders who want better feedback, traction and confidence without compromising everyday usability.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension know-how, these twin rear units are engineered to deliver controlled wheel movement and a more settled ride. The focus is on predictable damping behaviour and reliable performance over time.

Who this shock is for

  • Honda ST125 Dax riders chasing improved stability and feel from the rear end
  • Commuters and weekend riders wanting more control over bumps, braking and corner exits
  • Owners who value tuneability to suit load, tyres and road conditions

Shock design & features

This STX 36 twin-shock set uses a gas-pressurised monotube-style architecture with separated oil and gas to reduce fade and maintain damping consistency. The internal layout is aimed at delivering responsive control and better grip under changing surfaces and inputs.

Tuning controls

These shocks provide external damping adjustment for both rebound and compression, allowing you to tailor ride control and response to your preference. They also allow spring preload adjustment to suit rider weight and load.

Before you install

  • Confirm fitment for Honda ST125 Dax and check clearance with any aftermarket exhausts or accessories
  • Set sag and preload first, then fine-tune rebound and compression to match your roads and riding style
  • If the scooter carries a passenger or luggage regularly, plan a setup that suits the typical load

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO227
Model # S36PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 343.0
Spring Rate Standard 18.0 - 27.5 N/mm Progressive
Type Code S36PR1C1
Stroke Metal to Metal (mm) 99.5
Product Family STX 36 Scooter
Fitted Spring 60360-05

More From This Category