The Ohlins STX 46 Adventure rear shock for the Honda XL 750 Transalp is built for consistent damping control across mixed surfaces and long days in the saddle. It’s designed to maintain chassis stability when conditions change, from sealed roads to rougher tracks. External adjustability allows you to tailor feel and support to your riding and load without overcomplicating the setup.

Ohlins | Made to race, perfected to ride

Developed with Ohlins’ focus on precise damping behaviour and durability, this unit is aimed at riders who want a more controlled and predictable rear end in real-world adventure use. It suits those who regularly vary pace, terrain and carrying load.

Who this shock is for

  • Honda XL 750 Transalp riders mixing touring with unsealed-road travel
  • Riders carrying luggage or a pillion who want steadier ride height and control
  • Anyone chasing improved composure over corrugations and broken surfaces

Shock design & features

This is an oil/gas separated monotube design from the STX 46 Adventure family, intended to deliver stable damping under sustained use. The architecture is built to manage heat and maintain consistency when the pace or terrain demands more from the rear suspension.

Tuning controls

Adjustability includes rebound damping and compression damping, giving you a practical way to influence rear-wheel control, support and ride feel. A hydraulic spring preload adjuster is included to make load changes (luggage/pillion) easier to manage.

Base setup (factory preset)

The shock is supplied with an Ohlins-fitted spring and a baseline setting intended for the target application. From there, small changes to preload, rebound and compression can be used to suit rider preference and typical loading.

Before you install

  • Confirm the correct application for Honda XL 750 Transalp and check clearance around the reservoir and adjusters.
  • Set sag and preload before fine-tuning damping.
  • Use the recommended Ohlins shock oil when servicing.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO651
Model # S46HR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Shock Length Eye to Eye (mm) 347.5
Spring Rate Standard 95.0 N/mm
Type Code S46HR1C1S
Stroke Metal to Metal (mm) 76.5
Product Family STX 46 Adventure
Fitted Spring 01096-31
Rec. Ohlins Oil 01309-

More From This Category