The Ohlins HO910 STX 36 twin rear shock set is built for the Honda CB1100EX and designed to improve control and feel over a wide range of road conditions. The STX architecture uses a separated oil/gas design to maintain damping consistency as temperatures change. It’s a practical upgrade for riders who want predictable support without compromising day-to-day ride quality.

Ohlins | Made to race, perfected to ride

Ohlins twin shocks for classic and modern-retro platforms focus on stability, traction and clear feedback. This unit is configured specifically for the CB1100EX rear twin-shock layout. It is intended to deliver controlled damping behaviour with the adjustment range to tailor the ride to your load and roads.

Shock design & features

This is a twin-shock rear setup from the Ohlins STX 36 family with a separated oil/gas design rather than an emulsion layout. The internal design is aimed at consistent damping and reduced fade in sustained use. It suits road riding where composure and tyre contact matter most.

Tuning controls

Adjustment is provided for rebound damping to tune how quickly the rear returns after bumps and weight transfer. Spring preload adjustment is also provided to set ride height and support for different rider weight, luggage or a passenger. Together, these controls help you balance comfort, grip and chassis stability.

Before you install

  • Fitment note: does not fit Thailand version.
  • Check the lower bushing dimension requirement: 10 x 20 mm.
  • Confirm correct installation orientation and torque settings per Honda workshop guidance.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced to restore performance as oil and seals age. Periodic inspection for leaks, shaft condition and bushing wear will help maintain consistent damping and extend service life.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO910
Model # S36DR1L
Barcode # HO910
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 360.0 +10/-0
Spring Rate Standard 20.0 - 28.0 N/mm Progressive
Type Code S36DR1L
Stroke Metal to Metal (mm) 93.0
Product Family STX 36 Twin
Notes Does not fit Thailand version, lower bushing dimension 10x20mm
Fitted Spring 60480-04
Spring Colour Black

More From This Category