The Ohlins KA1994 TTX Flow Rear Shock is a rear mono shock absorber built for Kawasaki KX 450F fitment where consistent damping control and traction matter. It uses a pressurised gas design to help maintain damping stability as conditions and temperatures change. The TTX Flow architecture is intended to deliver clear chassis feedback and controlled movement through rough sections and heavy braking zones.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience, this unit focuses on controlled damping performance with a practical tuning range for motocross and enduro-style impacts. It is supplied without a spring, allowing you to select a rate to suit rider weight and use.

Who this shock is for

Suited to riders chasing more composure and grip from the rear end, particularly when accelerating out of corners, landing jumps, or riding through braking bumps. It is also a sensible choice if you want a higher level of adjustability than a basic OEM-style shock can provide.

Shock design & features

This is a gas-pressurised, oil/gas separated rear shock using the Ohlins TTX Flow concept with dedicated damping circuits. The aim is stable damping behaviour and predictable response across repeated impacts.

Tuning controls

Adjustment is provided for rebound damping and compression damping, with separate high-speed and low-speed compression control. This lets you tune support for bigger hits while retaining compliance over smaller chatter.

Before you install

  • No spring is supplied; a compatible spring must be selected and fitted (see product notes/spring series guidance).
  • Set sag and baseline adjusters after installation to suit rider weight, terrain and tyres.
  • Service intervals and oil choice should follow Ohlins recommendations for your use conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA1994
Model # T46PR1C1W
Barcode # KA1994
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 485.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category