The Ohlins YA039 TTX RT rear shock is built for Yamaha YZF R6 riders chasing consistent, controlled damping across fast track work and demanding road riding. The TTX architecture is designed to deliver stable chassis behaviour under braking, corner entry and drive. With separated oil and gas, damping stays consistent as temperatures rise.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing know-how, this unit focuses on predictable feedback and repeatable performance. It is intended as a complete replacement rear shock for the R6’s linkage-mounted mono position.

Who this shock is for

Suited to riders who want a rear end that remains composed when you increase pace, load the tyre harder, or change tyres and ride conditions. It’s a strong match for track days and competition use where accurate damping control matters.

Shock design & features

This is a TTX RT design using separated oil and gas rather than an emulsion layout, helping reduce aeration and maintain damping consistency. The layout supports stable pressure control and clear response to adjustment changes.

Tuning controls

Adjustments are provided for rebound damping and compression damping, allowing you to balance support, grip and stability to suit your setup and riding conditions. The design uses dedicated circuits for compression and rebound control.

Before you install

  • Confirm fitment for Yamaha YZF R6 and rear mono position before installation.
  • Set sag and geometry after installation to suit rider weight, tyre choice and intended use.
  • If you change springs or valving, plan to re-check damping settings and ride height.

Serviceability/lifecycle

Like all performance shocks, regular servicing helps maintain damping quality and seal life, especially with frequent track use. Keeping the oil fresh and the gas charge correct helps preserve the consistent feel the TTX design is known for.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA039
Model # T36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 293.0 +5-1
Spring Rate Standard 90.0 N/mm
Type Code T36PR1C1LB
Stroke Metal to Metal (mm) 60.0
Product Family TTX RT
Notes Type T36PR1C1LB
Fitted Spring 21041-29

More From This Category