The Ohlins YA014 is a rear shock absorber developed for Yamaha X-Max 250/300 applications where controlled damping and chassis stability matter. Built around the STX 36 architecture, it is designed to deliver consistent response through varied road and track conditions. This racing-version unit focuses on clear feedback and tunability rather than comfort-biased behaviour.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered to provide predictable damping control and repeatable adjustment. The YA014 follows that approach with a performance-oriented rear shock package suited to riders who want more authority over rear-end behaviour.

Who this shock is for

  • Riders using an X-Max 250/300 for fast road riding or track-focused use
  • Owners wanting improved stability under braking and through corner transitions
  • Anyone needing more tuning range than a standard rear unit provides

Shock design & features

This is a gas-pressurised, oil/gas-separated shock design intended to maintain damping consistency as conditions change. The STX 36 Twin family construction supports controlled fluid flow for stable, repeatable behaviour when riding hard.

Tuning controls

The YA014 provides external adjustment for both rebound damping and compression damping, allowing you to tailor the shock response to load, tyre choice, and riding conditions.

Before you install

  • Confirm fitment for Yamaha X-Max 250/300 and note this racing version is listed as replaced by YA 114
  • Set sag and verify spring suitability for your rider load and intended use
  • Record your baseline settings before making changes so you can return to a known setup

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA014
Model # S36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 347.0 +10
Spring Rate Standard 13.5 - 16.0 N/mm Progressive
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 95.5
Product Family STX 36 Twin
Notes Racing version *Replaced by YA 114*
Fitted Spring 60360-02

More From This Category