The Ohlins YA1694 TTX 44 rear shock is built for motocross and enduro riders chasing consistent damping control and clear chassis feedback. Based on Ohlins’ twin-tube TTX architecture, it’s designed to keep the rear end composed through braking bumps, corner entry and acceleration. This unit is supplied without a spring, allowing you to select a rate to suit rider weight and use.

Ohlins | Made to race, perfected to ride

TTX technology is aimed at delivering stable damping behaviour across a wide range of track conditions. The design focuses on control and repeatability, so the bike reacts predictably as the pace increases.

Who this shock is for

Suited to Yamaha YZ 450F riders who want more control from the rear suspension when riding hard, racing, or tuning for specific track conditions. It’s also a solid option when you want a higher-quality damper platform for ongoing setup work rather than a one-size compromise.

Shock design & features

This is an oil/gas separated design using Ohlins’ TTX twin-tube layout to help manage damping consistency during long motos and repeated high-load impacts. The internal layout is intended to maintain a stable feel as temperatures and track roughness change.

Tuning controls

The shock provides external adjustment for rebound damping and compression damping, letting you balance traction, support and recovery speed to suit track grip and bump severity.

Before you install

  • No spring is supplied. Fit the correct spring rate for your weight and riding, using the specified spring series noted for this unit.
  • Use the recommended Ohlins shock oil for servicing and setup consistency.
  • After installation, set sag and confirm clicker positions from the factory baseline before making track-side changes.

Serviceability/lifecycle

Like all performance shocks, it requires periodic servicing to keep damping consistent and to protect internal components. Regular oil changes and inspection of seals and wear items are important, especially in dusty or high-hour motocross use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA1694
Model # T44PR1C2W
Barcode # YA1694
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 458.0
Spring Rate No Spring/s Supplied
Type Code T44PR1C2W
Product Family TTX 44
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category