The Ohlins STX 46 Street rear shock for the Yamaha TDM 900 is built to improve chassis control and consistency in real-world road riding. It uses a gas-pressurised design to help maintain stable damping behaviour as conditions and pace change. The overall aim is clearer feedback, improved stability and a more controlled ride over varied surfaces.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension know-how, the STX 46 Street range is designed for riders who want a more controlled and confidence-inspiring rear end without compromising everyday usability. It’s a direct-fit rear mono shock solution for the TDM 900.

Who this shock is for

Suited to riders who want sharper rear-end control for spirited road rides, commuting, or touring with changing loads. It’s also a good match if you’re chasing improved stability under braking and better traction when driving out of corners.

Shock design & features

This is an oil/gas separated, gas-pressurised monotube-style shock architecture intended to reduce damping fade and maintain consistency. The STX 46 Street design focuses on predictable response and usable adjustment range for road conditions.

Tuning controls

Adjustability includes rebound damping and compression damping, allowing you to fine-tune ride feel and control to suit road surfaces, tyre choice and loading. Spring preload adjustment is provided to set sag correctly for rider weight and luggage/passenger changes.

Before you install

  • Set rider sag before making damping changes, then adjust rebound and compression one change at a time.
  • Confirm clearances around the reservoir/gas-pressurised body layout and ensure correct torque on all fasteners.
  • After initial rides, re-check sag and fasteners to confirm everything has bedded in correctly.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced and reconditioned, which helps keep damping performance consistent over time. Regular inspection and periodic servicing are recommended, especially if the bike sees frequent wet conditions or higher-mileage use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA208
Model # S46PR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 325.0
Spring Rate Standard 130.0 N/mm
Type Code S46PR1C1S
Stroke Metal to Metal (mm) 68.0
Product Family STX 46 Street
Fitted Spring 01095-49
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category