The Ohlins YA2192 is a rear TTX Flow shock absorber for Yamaha YZ 125/250 2-stroke motocross models. Built around Ohlins’ twin-tube architecture, it is intended to deliver consistent damping and clear chassis feedback across changing track conditions. It is supplied without a spring, allowing you to select the correct rate for your rider weight and use.

Ohlins | Made to race, perfected to ride

TTX Flow is Ohlins’ race-derived rear shock platform, designed for controlled damping performance and predictable feel. The twin-tube layout is focused on stable damping behaviour through the stroke, with good sensitivity to small bumps and support under load.

Shock design & features

This shock uses an oil/gas separated design. It is configured as a mono rear shock application and is intended for motocross/enduro use where repeated impacts and heat build-up demand consistent damping response.

Tuning controls

Adjustment is provided for rebound damping and compression damping. These controls let you tune how quickly the shock extends after an impact and how firmly it resists compression under bumps, braking loads, and acceleration.

Before you install

No spring is supplied. Select a compatible spring from the specified series noted for this model, then set sag and baseline adjustments before riding. If you are unsure on spring rate choice or setup direction, confirm your bike model details and intended use before ordering.

Serviceability/lifecycle

Like any high-performance motocross shock, regular servicing helps maintain damping consistency and seal life. Plan routine oil and wear-part refresh intervals suited to your riding conditions, and use the recommended Ohlins shock oil grade listed for this unit.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA2192
Model # T46PR1C1W
Barcode # YA2192
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 491.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- & 06451- spring series *Replaced by DMX 0204*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category