The Ohlins SH2184 TTX Flow DV is a rear shock absorber built for Sherco enduro models listed in this product title. It is designed to deliver controlled damping and consistent chassis behaviour across changing terrain. This unit is supplied without a spring, with the spring to be selected separately to suit the rider and application.

Ohlins | Made to race, perfected to ride

Developed from Ohlins off-road competition experience, the TTX Flow DV platform focuses on predictable damping control and usable adjustment range. The goal is stable handling and improved feel at the rear wheel when conditions and speed vary.

Shock design & features

  • TTX Flow DV rear mono-shock architecture for enduro use
  • Pressurised oil/gas design for more stable damping behaviour over a ride
  • Built as a dedicated fitment for the Sherco models specified in the product name
  • No spring supplied; spring is sold separately (refer to the notes for spring series guidance)

Tuning controls

This shock provides external adjustment for rebound damping and compression damping, allowing you to tailor support and traction to the track, terrain and tyre choice. Use rebound to manage how quickly the rear recovers after bumps, and compression to influence ride height control and impact resistance.

Before you install

  • Confirm spring selection before installation, as this unit is supplied without a spring
  • Check clearance and mounting condition at linkage and bearings while the shock is out
  • Use the recommended Ohlins suspension oil as specified for this unit

Serviceability/lifecycle

Like all performance off-road suspension, regular servicing helps maintain damping consistency and seal life, especially in muddy or dusty conditions. Plan periodic inspection and service intervals based on hours of use and operating environment.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SH2184
Model # T46PR1C2W
Barcode # SH2184
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 480.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C2W
Product Family TTX Flow DV
Notes 06310-& 06451- spring series *Replaced by DMX 0306*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category