The Ohlins SH1884 TTX Flow rear shock is built for Sherco enduro and motocross models where consistent damping and clear chassis feedback matter. It uses Ohlins’ TTX Flow architecture to manage oil flow efficiently through the damping system for predictable control across changing conditions. Supplied without a spring, it’s intended to be completed with the correct spring to suit the rider and bike.

Ohlins | Made to race, perfected to ride

TTX Flow is part of Ohlins’ competition-proven suspension range, developed to deliver stable behaviour and repeatable tuning. This unit is designed as a dedicated fitment for the listed Sherco platforms.

Shock design & features

  • TTX Flow rear mono shock design
  • Oil/gas separated shock construction for more consistent damping under heat and sustained use
  • Designed to run with a matching spring selected separately (no spring supplied)

Tuning controls

  • Compression damping adjustment
  • Rebound damping adjustment

Before you install

  • Confirm your exact Sherco model and year against the SH1884 application before fitting
  • Spring is not included; select a compatible spring from the noted spring series to suit rider weight and use
  • Use the recommended Ohlins shock oil as specified by Ohlins for this unit

Serviceability/lifecycle

This is a fully serviceable Ohlins rear shock. Routine servicing helps maintain damping consistency and seal life, especially for off-road use where contamination and heat load are higher.

Is it right for you?

Choose the SH1884 if you want an Ohlins TTX Flow rear shock for your Sherco and you value tunability via compression and rebound adjustment. If you’re not sure on spring choice or setup direction, plan the spring selection alongside your riding type and typical terrain.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SH1884
Model # T46PR1C1W
Barcode # SH1884
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 480.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category