The Ohlins STX 46 Street rear shock for Ducati Multistrada 1000/1100 is designed to improve damping control and chassis stability for road riding. Built around Ohlins race-derived damping know-how, it focuses on consistent response and predictable grip. This unit uses a gas-pressurised design to help maintain damping consistency as conditions change.

Ohlins | Made to race, perfected to ride

Ohlins Street shocks are developed to deliver controlled, repeatable damping on real roads. The aim is clearer feedback at the tyre contact patch and steadier behaviour under braking and acceleration.

Shock design & features

This is an oil/gas separated, gas-pressurised rear mono shock. The damping layout is intended to provide stable behaviour through a wide range of road speeds and loads while maintaining consistent performance.

Tuning controls

  • Rebound damping: adjustable to control how quickly the shock returns after compression
  • Compression damping: adjustable to manage support and impact control under braking and bumps
  • Spring preload: adjustable to set ride height and support for rider/load

Who this shock is for

Suited to Multistrada riders who want more control and stability than a basic OEM-style shock, especially when riding briskly, carrying luggage, or wanting more consistent damping feel. It also suits riders who prefer to fine-tune suspension response with external adjusters rather than relying on a fixed setting.

Before you install

  • Confirm compatibility with your Ducati Multistrada 1000/1100 and rear mounting position before installation.
  • Set sag and spring preload for your rider weight and typical load to get the best from the damping adjusters.
  • After fitting, recheck fasteners and clearance through suspension travel.

Serviceability/lifecycle

Like other performance shocks, this Ohlins unit is designed to be serviced to keep damping performance consistent over time. Regular inspection and periodic oil/gas service will help maintain the feel and control the shock was built to deliver.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU303
Model # S46PR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 295.5
Spring Rate Standard 105.0 N/mm
Type Code S46PR1C1S
Stroke Metal to Metal (mm) 61.5
Product Family STX 46 Street
Fitted Spring 01092-36
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category