The Ohlins FGYA1998 STX 22 Fork Cartridge Kit is designed to refine the front suspension behaviour of the Yamaha YZ 65. It focuses on improving damping control for clearer feel and stability through key phases like braking and turning. The result is a more composed and predictable front end that can be tuned to rider preference.

Ohlins | Made to race, perfected to ride

Built around Ohlins damping know-how, this cartridge kit is intended to deliver consistent control and feedback at the front wheel. It is a suspension solution aimed at riders chasing a more connected and confidence-inspiring ride.

Who this kit is for

  • YZ 65 riders wanting improved front-end feedback and stability
  • Riders looking to fine-tune fork behaviour to suit conditions and style
  • Anyone seeking more composure from the front suspension without changing the whole fork assembly

Shock design & features

  • Cartridge kit designed to improve damping characteristics in the fork
  • Premium internal components for consistent performance and durability

Tuning controls

  • Separate compression adjustment
  • Separate rebound adjustment

Before you install

  • Confirm compatibility with your Yamaha YZ 65 before fitting
  • Installation and setup should be carried out by a qualified suspension technician
  • After installation, allow time to test and adjust settings to suit your track and riding style

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FGYA1998
Model # STX Cartridge kit MX
Barcode # FGYA1998
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate No Spring/s Supplied
Type Code T22DR1C1
Fork Length (mm) 716.0
Stroke Metal to Metal (mm) 270.0
Product Family STX 22
Notes Recommended OEM spring 2,8 N/mm *Replaced by FCX 0104*
Rec. Ohlins Oil 01330-

More From This Category