The Ohlins HO140 STX 36 twin rear shock set is built for classic Honda road motorcycles that benefit from modern damping control without changing the character of the bike. It uses a pressurised gas design to keep damping consistent as conditions and temperatures vary. Supplied as a twin-shock arrangement for rear fitment on compatible Honda CB and CBX models.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension engineering, this STX 36 twin setup focuses on controlled damping response and predictable rear-wheel behaviour. It is intended for riders who want a more composed chassis feel and clearer feedback through the rear suspension.

Who this shock is for

Suited to owners of Honda CB 750 F, CB 750 KZ, CB 900, CB1100F, CB1100R and CBX 1000 models running a twin rear shock configuration. A good match for road riding where stability and control matter, including spirited riding on varied surfaces.

Shock design & features

This is a gas-pressurised twin rear shock design. The pressurised internal layout helps reduce the likelihood of aeration in the oil under demanding use, supporting consistent damping feel over a ride.

Tuning controls

This model provides damping adjustment for both rebound and compression, allowing you to balance support, grip and chassis attitude to suit your bike and riding conditions. It also includes spring preload adjustment to set sag appropriately for rider load.

Before you install

  • Confirm your exact model and year are listed for compatibility before fitting.
  • Set sag and baseline damping after installation, then fine-tune in small steps.
  • Inspect linkage, swingarm bushes and mounting hardware condition to ensure the shock can perform as intended.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO140
Model # S36P
Barcode # HO140
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 364.0
Spring Rate Standard 18.0 - 27.0 N/mm Progressive
Type Code S36P
Stroke Metal to Metal (mm) 97.0
Product Family STX 36 Twin
Fitted Spring 00480-03
Spring Colour Black

More From This Category