The Ohlins STX 46 Street rear shock for the Honda CB750 Hornet is engineered to improve damping control and chassis stability for everyday road riding. Built around Ohlins race-developed damping know-how, it delivers clearer feedback and more consistent support through corners and under braking. This unit uses a gas-pressurised design to help maintain damping consistency as conditions change.

Ohlins | Made to race, perfected to ride

Ohlins street shocks are developed to provide controlled, predictable suspension behaviour without compromising real-world comfort. The STX 46 Street range focuses on stable damping, strong mid-stroke support and confidence-inspiring feel for road use.

Shock design & features

  • STX 46 architecture designed for road-focused performance and durability
  • Gas-pressurised damping system to help reduce fade and maintain consistency
  • Separate damping circuits to support accurate tuning changes

Tuning controls

This rear shock includes external damping adjustments for both compression and rebound, allowing you to tailor support and feel to your tyres, load and riding conditions. Spring preload adjustment is also provided to set ride height and sag for solo riding or added luggage.

Base setup (factory preset)

The shock is supplied with an Ohlins-developed base setting intended to suit the standard motorcycle in typical street conditions. From that baseline, compression, rebound and preload can be refined to match rider mass, pace and preferred balance.

Before you install

Confirm the bike model/variant and that no other chassis changes (linkage, ride height changes or non-standard swingarm components) affect fitment. After installation, set sag first, then adjust rebound and compression one change at a time to keep the result clear and repeatable.

Serviceability/lifecycle

Like all performance dampers, this shock is designed to be serviced to maintain consistent damping performance over time. Periodic inspection and servicing will help preserve seal condition, oil quality and overall damping consistency.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO750
Model # S46PR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 314.0
Spring Rate Standard 130.0 N/mm
Type Code S46PR1C1S
Stroke Metal to Metal (mm) 61.0
Product Family STX 46 Street
Fitted Spring 01092-49
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category