The Ohlins STX 36 Blackline rear shock pair is built for Yamaha XJR 1200 and XJR 1300 models, combining proven damping architecture with a classic finish. Designed as a matched twin-shock set, it targets improved control and consistency through adjustable damping and preload. Setup changes can be made to suit different loads and riding conditions while keeping the bike’s character intact.

Ohlins | Made to race, perfected to ride

STX 36 Blackline units are engineered as street-focused performance shocks, with quality materials and damping control intended for real-world road use. The Blackline finish is chosen to suit vintage and custom aesthetics without compromising function.

Shock design & features

This is a twin rear shock configuration for the XJR platform, supplied as a pair. The design uses oil and gas separation for stable damping performance, helping the shocks maintain consistent behaviour as conditions change.

Tuning controls

  • Rebound damping adjustment to control how quickly the shock extends after compression
  • Compression damping adjustment to manage firmness and support over bumps and load transfers
  • Spring preload adjustment to set ride height and support for rider, passenger, or luggage

Base setup (factory preset)

These shocks are delivered with an Ohlins factory baseline intended as a safe starting point for typical street riding. Fine-tuning rebound, compression, and preload can then be used to suit road surface, tyres, and load.

Before you install

Confirm your exact model and year fitment for Yamaha XJR 1200 / XJR 1300 and inspect linkage and mounting hardware condition before installation. After fitting, re-check fasteners, set sag via preload, and make damping changes one step at a time to isolate their effects.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA964
Model # S36PR1C1L (B)
Barcode # YA964
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 325.0 +10/0
Spring Rate Standard 20.0 - 29.0 N/mm Progressive
Type Code S36PR1C1L (B)
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Blackline
Fitted Spring 00360-06
Spring Colour Black

More From This Category