The Ohlins STX 36 twin rear shock is a direct-fit upgrade for classic and modern Kawasaki models using twin shocks. Built around a pressurised, oil/gas separated damping layout, it’s designed to deliver stable, consistent damping feel across varied street and spirited riding conditions. External adjusters let you fine-tune the chassis balance without chasing unnecessary complexity.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered with a focus on controlled damping behaviour and repeatable tuning. The STX platform brings that approach to street-focused twin-shock applications where predictable rear grip and composure matter.

Who this shock is for

  • Riders wanting more control and consistency than ageing OEM twin shocks.
  • Street and weekend riders who value chassis stability through corners and over rough surfaces.
  • Owners setting up a well-sorted road bike where adjustability and serviceability are priorities.

Shock design & features

  • STX 36 twin-shock architecture with oil/gas separation to help maintain damping stability during extended riding.
  • Pressurised design intended to reduce fade and keep response consistent as temperatures change.
  • Designed as a rear twin-shock fitment for the listed Kawasaki applications.

Tuning controls

  • Rebound damping adjustment.
  • Compression damping adjustment.

Before you install

  • Confirm fitment to your exact model and year within Kawasaki Z 1000, Z 750 GP, Z900, and Zephyr 1100 ranges.
  • Set sag and baseline adjusters after installation to suit your load, tyres, and riding conditions.
  • Inspect linkage/bushings and mounting hardware condition so the shock can work as intended.

Serviceability / lifecycle

This Ohlins unit is designed to be maintained and rebuilt. Periodic servicing helps preserve damping consistency and seal life, especially if the bike sees regular hard road use or long rides in varying conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA414
Model # S36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 347.0 +10/-0
Spring Rate Standard 18.0 - 27.0 N/mm Progressive
Type Code S36PR1C1LB
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Twin
Fitted Spring 00480-13
Spring Colour Yellow

More From This Category