The Ohlins YA943 is a rear twin-shock unit for the Yamaha V-Max, built around Ohlins’ STX architecture for controlled, consistent damping on the road. It’s designed to improve chassis stability and tyre contact through varying surfaces and loads. With external adjusters for key damping functions, it supports practical tuning without making the bike feel over-suspended.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control and repeatability, aiming for predictable behaviour across a wide range of riding conditions. This unit follows that approach, delivering a balanced feel that can be tuned to suit your pace and preferences.

Shock design & features

  • Twin rear shock configuration to suit the V-Max chassis layout.
  • Oil and gas are separated to help maintain damping consistency during sustained use.
  • Spring preload adjustment to help set ride height and support for rider/passenger/load changes.

Tuning controls

  • Rebound damping adjustment to control how quickly the shock extends after compression.
  • Compression damping adjustment to manage support and control under bumps and load transfer.
  • Spring preload adjustment for setting sag and overall support.

Base setup (factory preset)

This shock is supplied with an Ohlins baseline setting intended to be a safe starting point for general street use. Final setup should be confirmed by checking sag and then making small, methodical damping changes to suit tyre choice, load and riding conditions.

Before you install

  • Inspect mounting points and hardware condition before fitting.
  • Set sag after installation and re-check fasteners after the first ride.
  • If you’re changing tyres or typical load, plan to revisit preload and damping to match.

Serviceability/lifecycle

As a serviceable Ohlins unit, periodic maintenance helps keep damping performance consistent over time. Service intervals depend on use conditions, but regular oil and seal inspection is recommended for long-term reliability.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA943
Model # S46PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 324.0
Spring Rate Standard 20.0 N/mm
Type Code S46PR1C1
Stroke Metal to Metal (mm) 85.0
Product Family STX 36 Twin
Fitted Spring 01102-06

More From This Category