The Ohlins STX 36 twin shock unit for Kawasaki applications is built for riders who want consistent rear-end control and clear feedback from the chassis. As a twin-shock layout, it suits classic and retro-styled frames that rely on matched left and right dampers. It is a gas-pressurised design intended to maintain damping consistency across a wide range of road conditions.

Ohlins | Made to race, perfected to ride

Ohlins suspension units are engineered with a focus on damping stability, serviceability and predictable tuning. This STX 36 twin shock follows that approach with a road-focused configuration for modern and classic Kawasaki platforms.

Who this shock is for

  • Riders of twin-shock Kawasaki models looking to improve rear grip and control compared with ageing or tired suspension.
  • Owners who value accurate feel during braking, corner entry and corner exit on spirited road rides.
  • Builders restoring or upgrading Z and Zephyr-based bikes who want a proven Ohlins twin-shock format.

Shock design & features

  • STX 36 twin-shock architecture for rear twin-shock fitment.
  • Gas-pressurised damping system to help keep performance consistent.
  • Designed as a matched rear pair for left/right installation.

Tuning controls

  • Rebound damping adjustment.

Before you install

  • Confirm model compatibility for Kawasaki Z 1000, Z 750 GP, Z900 and Zephyr 1100 before fitting.
  • Plan a setup check after installation to ensure the bike is balanced front-to-rear for your load and riding use.

Serviceability/lifecycle

Ohlins units are designed to be maintained. Periodic servicing helps preserve damping consistency and keeps adjusters operating as intended over time.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA140
Model # S36P
Barcode # KA140
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 347.0
Spring Rate Standard 18.0 - 27.0 N/mm Progressive
Type Code S36P
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Twin
Fitted Spring 00480-03
Spring Colour Black

More From This Category