The Ohlins MG250 STX 36 twin rear shock set is designed for Moto-Guzzi Le Mans I-II 850 fitment, focusing on stability and controlled damping feel. Built around Ohlins street-oriented twin shock architecture, it targets predictable chassis behaviour across varied road conditions. This listing does not include adjustment details, so confirm tuning controls before purchase if adjustability is critical to your setup.

Ohlins | Made to race, perfected to ride

Ohlins twin shock units are developed from proven damping principles used across road and competition applications. The STX 36 Twin family is intended to deliver consistent control, with a focus on usable feedback and traction.

Who this shock is for

  • Riders restoring or updating suspension performance on a Moto-Guzzi Le Mans I-II 850 with a quality twin shock solution
  • Owners who want a more controlled rear end response without moving away from the twin shock layout
  • Setups where predictable feel and stability are prioritised over extreme adjustability

Shock design & features

  • Rear twin shock configuration from the Ohlins STX 36 Twin product family
  • Gas-pressurised damping system for consistency during sustained use
  • Designed to support stable handling and improved traction feel

Tuning controls

Adjustment functions (such as rebound and compression control) are not specified in the provided product data. If you need confirmed adjusters for your application, verify the exact configuration before ordering.

Before you install

  • Confirm motorcycle model and year compatibility for Moto-Guzzi Le Mans I-II 850 and rear twin shock fitment
  • Inspect mounting hardware and bushings during installation and replace worn components as required
  • Set sag and check clearances after fitting to suit your rider load and intended use

Serviceability/lifecycle

Ohlins shocks are built to be serviced. Periodic inspection and maintenance helps preserve damping performance and seal life, especially on older motorcycles or those used regularly.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU MG250
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 325.0
Spring Rate Standard 12.0 - 19.0 N/mm Progressive
Stroke Metal to Metal (mm) 90.0
Product Family STX 36 Twin
Fitted Spring 00480-02

More From This Category