The Ohlins ACE rear shock pair is designed as a direct-fit suspension upgrade for Yamaha XJR 1200/1300 models. Built around Ohlins street-focused engineering, it targets improved control and consistency over a wide range of real-world road surfaces. This listing is supplied as a pair with yellow springs.

Ohlins | Made to race, perfected to ride

Ohlins road shocks are developed with a focus on predictable damping behaviour and durable construction. They are intended to work as a complete unit, balancing comfort, grip and stability without relying on extreme settings.

Who this shock is for

Suited to riders who want a higher-quality rear suspension feel on the XJR platform, including those carrying a passenger, adding luggage, or simply wanting more composed damping on rough or undulating roads. Also appropriate for owners refreshing ageing rear suspension with a serviceable aftermarket unit.

Shock design & features

This product is a matched pair of rear shock absorbers for street use. The “ACE” naming indicates an Ohlins application-specific fitment intended to integrate cleanly with the motorcycle’s standard mounting points and geometry.

Tuning controls

Adjustment details are not provided in the input data for this model. Confirm the exact adjusters and their locations on the shocks themselves before installation and setup.

Before you install

  • Verify fitment for your exact XJR year/model before ordering or fitting.
  • Inspect mounting hardware and bushes during installation and replace worn components as needed.
  • Set rider sag and confirm clearance at full suspension travel once installed.

Serviceability/lifecycle

Ohlins shocks are built to be serviced to maintain performance over time. Plan periodic servicing based on use conditions and mileage to keep damping consistent.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA227
Barcode # YA227
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category