The Ohlins SU937 STX 36 Twin rear shock set is built for the Suzuki VS 1400 and is designed to deliver controlled, consistent damping on the road. Using a gas-pressurised, oil/gas separated layout, it helps maintain damping stability as conditions change. The twin-shock format suits the original chassis architecture while providing a more precise, tuneable suspension response.

Ohlins | Made to race, perfected to ride

Ohlins STX technology brings race-derived damping concepts into a street-focused package. The emphasis is on controlled wheel movement, predictable chassis behaviour and a stable feel through corners and braking transitions.

Who this shock is for

  • Suzuki VS 1400 riders wanting improved rear-end control and consistency
  • Owners seeking a higher-quality twin-shock replacement with tuneability
  • Riders who value clear chassis feedback rather than a soft, under-damped feel

Shock design & features

  • STX 36 Twin architecture
  • Gas-pressurised damping with oil/gas separation to support consistent performance
  • Rear twin-shock fitment for the VS 1400 chassis

Tuning controls

This model provides external damping adjustment for both compression and rebound, allowing you to balance comfort, support and grip for your riding conditions. Adjustments are intended to be made methodically, one change at a time, to maintain a predictable baseline.

Before you install

  • Confirm the supplied springs and hardware match your application and intended load
  • Inspect linkage and mounting points for wear before fitting new shocks
  • After installation, re-check fasteners and verify smooth suspension movement through travel

Serviceability/lifecycle

As with other Ohlins units, periodic servicing helps maintain damping performance and internal condition over time. Regular inspection for leaks and changes in feel is recommended, particularly if the bike sees frequent use or varied road conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SU937
Model # S36E
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 333.0
Spring Rate Standard 20.0 - 27.0 N/mm Progressive
Type Code S36E
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Twin
Fitted Spring 03195-04

More From This Category