The Ohlins HO142 is a rear twin-shock unit from the STX 36 Twin family, built to suit the Honda CB 400 Super Four. It focuses on consistent damping control and clear chassis feedback for road riding where stability and grip matter. This model uses a gas-pressurised damping design to help maintain performance as conditions and temperatures change.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a strong engineering focus on damping control, ride quality and durability. On a classic twin-shock layout, the aim is predictable support under braking, through corners and on varied road surfaces.

Who this shock is for

Designed for CB 400 Super Four riders running a rear twin-shock arrangement who want a more controlled and tunable setup than a basic replacement shock. It suits riders who value stability and confidence from the rear end during everyday road use and spirited riding.

Shock design & features

This is a gas-pressurised rear shock configuration intended to reduce fade and keep damping behaviour consistent. As a twin-shock setup, it supports the bike’s original architecture while upgrading damping quality and overall composure.

Tuning controls

The HO142 provides damping adjustment for both compression and rebound, allowing you to tailor support and response to your riding conditions. Spring preload adjustment is used to set ride height and sag correctly for the rider and load.

Before you install

Confirm fitment for your exact CB 400 Super Four variant and check clearance around guards, chain and exhaust. Set sag and baseline damping after installation, then make changes one at a time to understand the effect of each adjustment.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO142
Model # S36P
Barcode # HO142
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 330.0
Spring Rate Standard 12.0 - 19.0 N/mm Progressive
Type Code S36P
Stroke Metal to Metal (mm) 88.0
Product Family STX 36 Twin
Fitted Spring 00480-02
Spring Colour Black

More From This Category