The Ohlins TTX 36 rear shock for the Honda CB1000 Hornet is built around a twin-tube damping layout to deliver stable, consistent control across changing road and track conditions. It uses a separated oil/gas design to help maintain damping consistency as temperatures rise. The result is clearer feedback at the tyre contact patch and more predictable chassis behaviour when you start pushing the pace.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing know-how, this unit focuses on repeatable damping performance and tuneability without compromising day-to-day ride quality. It is intended as a complete replacement rear mono shock for the CB1000 Hornet.

Who this shock is for

  • Street riders wanting more composed rear-end control under braking, turn-in and acceleration
  • Track day riders chasing consistent damping feel session after session
  • Owners who want suspension adjustability to suit tyre choice, loads, and riding style

Shock design & features

  • TTX twin-tube architecture for balanced damping behaviour
  • Separated oil/gas pressurised system to support damping consistency
  • Application-specific valving for the Honda CB1000 Hornet rear linkage and chassis dynamics

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Before you install

  • Confirm sag and preload are set for your weight and intended use before evaluating damping changes
  • After installation, re-check fasteners and clearances through full suspension travel
  • If you regularly carry a passenger or luggage, plan to revisit preload and damping settings

Serviceability/lifecycle

Like all high-performance suspension, periodic servicing helps maintain damping consistency and seal reliability over time. A scheduled refresh is recommended if performance begins to change, or if the shock has seen regular hard use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO261
Model # T36PR1C1B
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 324.0
Spring Rate Standard 145.0 N/mm
Type Code T36PR1C1B
Stroke Metal to Metal (mm) 55.0
Product Family TTX 36
Fitted Spring 21141-56
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category