The Ohlins HO414 STX 36 Twin rear shock set is built for the Honda CB 1300, delivering controlled damping and stable chassis behaviour for road riding. The design uses a gas-pressurised system to help maintain consistent performance as conditions change. It also provides external adjustments so you can tailor feel and support to your riding style.

Ohlins | Made to race, perfected to ride

Ohlins STX 36 Twin units are developed from the brand’s suspension engineering background, with a focus on predictable response and repeatable damping control. This model is intended as a direct-fit rear twin-shock solution for the CB 1300.

Shock design & features

  • STX 36 Twin rear shock configuration for twin-shock applications
  • Gas-pressurised damping system for consistent damping behaviour
  • Separate damping circuits to support controlled chassis movement

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Length adjustment to fine-tune rear ride height and geometry

Who this shock is for

  • Honda CB 1300 riders wanting clearer feedback and improved stability from the rear suspension
  • Riders who value adjustability to suit load, tyres, and road conditions

Before you install

  • Confirm correct fitment for your CB 1300 model and year before installation
  • After fitting, check sag and damping settings so the adjusters start from a sensible baseline

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO414
Model # S36PR1C1L
Barcode # HO414
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 365.0 +8/-2
Spring Rate Standard 20.3 - 28.6 N/mm Progressive
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Twin
Fitted Spring 00480-23
Spring Colour Black

Related products

More From This Category