The Ohlins HO816 STX 36 rear shock pair is built for the Honda SH 150, delivering controlled damping and a more settled feel across varied road conditions. As a matched twin-shock set, it targets consistent rear-end support and clear feedback without compromising everyday usability. Designed within the STX 36 Scooter family, it focuses on predictable response and durability for regular street use.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with proven design practices and refined for real-world riding. The HO816 applies that approach to the SH 150 platform with a purpose-built rear twin-shock configuration.

Who this shock is for

  • Honda SH 150 riders wanting improved rear stability and consistency from a dedicated Ohlins setup
  • Daily commuters and weekend riders seeking better control over changing surfaces
  • Owners replacing worn original shocks with a serviceable performance option

Shock design & features

This is a rear twin-shock pair from the Ohlins STX 36 Scooter range. It uses a gas-pressurised, oil/gas separated damping system to help maintain consistent performance as conditions and workload change.

Tuning controls

The HO816 provides external adjustability for rebound damping and compression damping, allowing the rear suspension response to be tailored to rider preference and typical loads.

Before you install

  • Confirm fitment for Honda SH 150 and check overall condition of mounts and bushings during installation
  • Set sag and balance front-to-rear after installation for best handling
  • After initial rides, re-check fasteners and review settings to suit your roads and carrying load

Serviceability/lifecycle

Ohlins shocks are designed to be maintained. Periodic servicing helps keep damping performance consistent over the life of the shocks and supports long-term reliability.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO816
Model # S36PR1C1
Barcode # HO816
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 377.0
Spring Rate Standard 10.0 - 14.0 N/mm Progressive
Type Code S36PR1C1
Stroke Metal to Metal (mm) 99.0
Product Family STX 36 Scooter
Fitted Spring 60480-01
Rec. Ohlins Oil 01309-

More From This Category