The Ohlins STX 46 Adventure rear shock for the Honda XL 600 V Transalp is built to improve control and ride quality when conditions and loads vary. It is designed for long-distance adventure and touring use where traction, stability and consistency matter. This unit supports practical tuning for different terrain and carrying requirements.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control and repeatable performance in real-world riding. The STX Adventure platform is aimed at mixed-surface use, where comfort and chassis stability need to work together.

Shock design & features

This is a monotube shock with a separated oil and gas design to help maintain damping consistency over sustained rough-road use. It is intended for rear fitment on the Transalp and suits adventure-touring conditions where heat management and control are priorities.

Tuning controls

This shock provides external rebound damping adjustment to refine how the rear recovers after bumps and undulations. It also includes an external preload adjuster to set ride height and support for changes in rider weight, luggage or a pillion.

Base setup (factory preset)

The shock is supplied with an Ohlins baseline setting intended as a starting point for the application. Use preload to achieve the correct stance for your typical load, then adjust rebound to balance comfort, grip and stability across your usual surfaces.

Before you install

Inspect linkage bearings and mounting hardware, and address any wear before fitting new suspension. After installation, set sag and verify clearance through the full range of travel, especially if you regularly carry added load.

Serviceability/lifecycle

Like all performance dampers, this shock is serviceable and benefits from periodic oil and seal maintenance to keep damping consistent. Service intervals depend on use and conditions, with frequent dirt or corrugation riding typically requiring more regular attention.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO836
Model # S46ER1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 355.0
Spring Rate Standard 120.0 N/mm
Type Code S46ER1
Stroke Metal to Metal (mm) 83.0
Product Family STX 46 Adventure
Notes Type S46ER1
Fitted Spring 01096-44

More From This Category