The Ohlins STX 46 Street rear shock for Honda BROS and Hawk is built around proven damping architecture to deliver consistent control and clear chassis feedback on the road. It’s designed for riders who want more stability and traction without losing ride quality. Gas pressurisation helps keep damping consistent as conditions and pace change.

Ohlins | Made to race, perfected to ride

Ohlins street shocks carry over race-developed know-how into a package intended for everyday riding. The focus is predictable response, stability under load changes, and confidence when the surface is less than perfect.

Who this shock is for

Suited to riders of Honda BROS and Hawk models looking for a higher level of damping control than a basic replacement shock. It’s a sensible choice if you ride briskly on the street, value feedback mid-corner, or want a more composed rear end under braking and acceleration.

Shock design & features

This is an STX 46 Street monotube rear shock with gas-pressurised, oil/gas separated damping to reduce fade and maintain consistency. The internal layout supports stable operation over repeated heat cycles, helping the bike stay settled through long rides and variable road conditions.

Tuning controls

Adjustment is provided for rebound damping and compression damping, allowing you to tailor support and response to your riding style and typical road surfaces. These controls help you balance comfort against chassis control, and fine-tune traction during corner entry and exit.

Before you install

  • Confirm model fitment for your Honda BROS/Hawk variant and any linkage or clearance considerations.
  • Set sag and balance front-to-rear after installation to get the best handling result.
  • Record your starting settings so you can make changes methodically during test rides.

Serviceability/lifecycle

Like other Ohlins units, this shock is designed to be serviced to maintain performance over time. Routine servicing restores damping consistency and protects internal components, particularly if the bike is used frequently or in demanding conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO847
Model # S46HR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 307.0 +12/-0
Spring Rate Standard 190.0 N/mm
Type Code S46HR1C1L
Stroke Metal to Metal (mm) 47.0
Product Family STX 46 Street
Fitted Spring 01093-79
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category