The Ohlins HO911 STX 36 twin rear shock set is built for the Honda CB1100EX, using a pressurised damping design aimed at stable, consistent control on the road. It suits riders who want a suspension solution that can be tuned to match load, tyres and riding conditions. This is a twin-shock rear application and is supplied as an Ohlins unit designed for street use.

Ohlins | Made to race, perfected to ride

STX 36 Twin is Ohlins’ twin-shock platform for modern and classic-style motorcycles where predictable damping and chassis support matter. The design targets consistent performance by keeping damping behaviour stable as the shock works through its stroke.

Who this shock is for

  • CB1100EX riders upgrading worn or under-controlled stock rear suspension
  • Riders carrying a passenger or luggage who want more control and adjustability
  • Owners who value tunability and serviceability in a quality twin-shock setup

Shock design & features

This is a gas-pressurised, oil/gas separated rear shock design intended to maintain damping consistency during sustained riding. The architecture supports stable damping response and improved chassis feedback compared with non-pressurised designs.

Tuning controls

The HO911 provides external damping adjustment for both rebound and compression, plus spring preload adjustment to set ride height support for rider weight and load. These controls allow fine tuning for comfort, grip and stability without internal modifications.

Before you install

  • Fitment note: does not fit Thailand version.
  • Lower bushing dimension: 10 x 20 mm.

Serviceability / lifecycle

As an Ohlins unit, the shock is designed to be serviced and reconditioned to maintain performance over time. Routine inspection and periodic servicing help keep damping and seals in good condition.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO911
Model # S36PR1C1L
Barcode # HO911
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 360.0 +8/-2
Spring Rate Standard 20.0 - 28.0 N/mm Progressive
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 93.0
Product Family STX 36 Twin
Notes Does not fit Thailand version, lower bushing dimension 10x20mm
Fitted Spring 60480-14
Spring Colour Yellow

More From This Category