The Ohlins STX 46 Street rear shock is built for riders who want more control and consistency from the Honda CB650R and CBR650R chassis. It is a gas-pressurised, oil/gas separated design intended to maintain stable damping behaviour as conditions change. Developed from Ohlins suspension know-how, it focuses on clear feedback and predictable support in everyday road use.

Ohlins | Made to race, perfected to ride

Ohlins street suspension is designed to bring race-derived damping control into real-world riding. The aim is a calmer, more composed motorcycle that communicates grip and load changes more clearly.

Who this shock is for

  • CB650R and CBR650R riders chasing improved rear-end support and feel
  • Riders who want the ability to tune damping to suit roads, tyres, and load
  • Owners looking for a purpose-built rear mono shock for street use

Shock design & features

This unit uses a gas-pressurised damping system with oil and gas separated to help reduce damping fade and maintain consistent behaviour. The architecture is based around Ohlins STX 46 Street design principles, prioritising stability and controlled movement through the stroke.

Tuning controls

Adjustability includes rebound damping and compression damping, allowing you to refine chassis response for comfort, grip, and stability. These controls are intended to help match the bike to rider preference and changing riding conditions.

Before you install

  • Rear mono shock fitment for Honda CB650R and CBR650R applications
  • Supplied with an Ohlins spring fitted (01092-84, yellow)
  • After installation, set sag and confirm damping settings suit your rider weight and typical load

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO913
Model # S46HR1C1
Barcode # HO913
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 332.0
Spring Rate Standard 200.0 N/mm
Type Code S46HR1C1
Stroke Metal to Metal (mm) 52.0
Product Family STX 46 Street
Fitted Spring 01092-84
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category