The Ohlins KA889P TTX RT rear shock absorber is built for riders looking for consistent chassis control on a Kawasaki ZX-6R. It uses a gas-separated damping layout to keep oil control stable as conditions and temperatures change. The TTX architecture is designed to deliver predictable feel and repeatable adjustment without making the bike harsh.

Ohlins | Made to race, perfected to ride

Developed from Ohlins road racing experience, this unit focuses on maintaining traction and stability through braking, turn-in and drive. The intent is clear feedback at the tyre, so setup changes are easier to evaluate.

Who this shock is for

Suited to track-focused ZX-6R riders and those who want more control than a standard rear unit can offer. It also suits riders who need damping consistency during longer sessions where heat management matters.

Shock design & features

This is a TTX RT rear mono shock with separate oil and gas to reduce aeration and help damping remain consistent. The damping circuits are designed for stable response under load changes, supporting the bike when braking hard and accelerating out of corners.

Tuning controls

Adjustment is provided for rebound damping and compression damping, allowing you to balance support and grip to match tyres, track surface and riding style. The design supports making changes in a controlled, repeatable way during setup work.

Before you install

This unit is intended for the rear mounting position on the Kawasaki ZX-6R. Professional installation and setup are recommended so ride height, sag and damping settings can be checked as a complete package.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA889P
Model # T36PR1C1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Type Code T36PR1C1LS
Stroke Metal to Metal (mm) 64.0
Product Family TTX RT

More From This Category