The Ohlins SU360 TTX GP rear shock for the Suzuki GSX-R 1000 is a track-focused upgrade built around Ohlins race-derived damping control. It is designed to improve tyre contact feel and chassis stability under aggressive riding. This unit uses a pressurised damping system to help maintain consistency as conditions and temperatures change.

Ohlins | Made to race, perfected to ride

TTX GP products are developed from Ohlins competition programs, with a focus on predictable response and repeatable tuning. The SU360 is intended for riders who want clear feedback and controllable grip when pushing on track.

Who this shock is for

  • Suzuki GSX-R 1000 riders prioritising track performance and consistent damping feel
  • Riders looking for sharper feedback and improved stability under braking and on corner exit
  • Owners who want a suspension unit designed for precise tuning rather than a fit-and-forget replacement

Shock design & features

This is a gas-pressurised rear mono shock using the Ohlins TTX GP architecture, aimed at stable damping performance during hard use. The internal layout is intended to support controlled response at higher shaft speeds for improved chassis composure.

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

Confirm fitment for your exact GSX-R 1000 model and year, and check clearance around the linkage and exhaust. This product is noted as replaced by SU 466, so verify availability and supersession requirements before ordering or servicing.

Serviceability/lifecycle

As a performance shock, regular servicing helps maintain damping consistency and seal condition, particularly with frequent track use. Plan for periodic oil and wear-part replacement as part of normal ownership.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SU360
Model # T36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 320.0 +4/-2
Spring Rate Standard 95.0 N/mm
Type Code T36PR1C1LB
Stroke Metal to Metal (mm) 63.0
Product Family TTX GP
Notes *Replaced by SU 466*
Fitted Spring 21040-31
Spring Colour Yellow

More From This Category