The Ohlins AP827 STX 46 Supersport rear shock is an Ohlins unit developed for the Aprilia RSV 1000 R to deliver controlled damping and clear chassis feedback. It uses a gas-pressurised, oil/gas separated design to help maintain consistency as conditions and pace change. External adjustments allow the rear to be tuned for tyres, track surface and rider preference.

Ohlins | Made to race, perfected to ride

STX 46 Supersport products are built around stable damping behaviour and predictable feel as loads change. The intent is to provide a wider usable window for grip and support, while keeping a clear connection to what the rear tyre is doing.

Shock design & features

This is a rear mono-shock in the STX 46 Supersport family. The gas-pressurised layout keeps oil and gas separated to help reduce aeration and maintain damping consistency. The design is intended to deliver controlled support through transitions such as braking release and drive off corners.

Tuning controls

The AP827 provides rebound damping adjustment to control how quickly the shock extends after compression, influencing stability and traction over successive bumps. It also provides compression damping adjustment to influence how the rear settles under load, affecting support and feel during corner entry and acceleration. Ride height adjustment is included to fine-tune chassis attitude and balance.

Base setup (factory preset)

The supplied baseline is intended to be a practical starting point with a correctly maintained linkage and an appropriate spring choice. From there, damping adjustments are used to match tyre construction, rider pace and the level of support desired.

Before you install

Verify rear sag and inspect the linkage and bearings for free movement and correct condition before fitting. Make damping changes one at a time and assess traction, stability and line-holding. If balance changes significantly, revisit ride height and overall front-to-rear attitude.

Serviceability/lifecycle

Regular servicing helps maintain consistent damping and seal condition. If performance changes or adjustments become less effective, a service and inspection is recommended to restore correct operation.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU AP827
Model # S46PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 311.0 +5.5/-0.5
Spring Rate Standard 95.0 N/mm
Type Code S46PR1C1L
Stroke Metal to Metal (mm) 63.5
Product Family STX 46 Supersport
Fitted Spring 01091-31
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category