Ohlins ACE rear shock absorbers for the Honda CB 750 (RC42), supplied as a matched pair. Built around Ohlins street-focused design practices, these units are intended to improve control and consistency over a wide range of road conditions. This listing information does not include adjustment or internal design details.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on predictable damping behaviour and long-term support. For road bikes, the aim is improved composure without compromising day-to-day usability.

Who this shock is for

Suited to CB 750 (RC42) owners wanting a quality replacement or upgrade to the rear suspension with an Ohlins matched set. Appropriate for regular street riding where stability and feel matter.

Shock design & features

This product row does not specify whether the shocks use an emulsion design or a separated gas/oil layout, and does not confirm the internal architecture. It is supplied with black springs and is sold as a pair.

Tuning controls

Adjustment features are not stated in the provided data. Confirm the available tuning controls for this exact model before purchase if adjustability is important for your setup.

Before you install

Verify fitment to Honda CB 750 (RC42) and check clearance around guards, chain line, and exhaust. After installation, set static and rider sag and inspect fasteners after the first rides.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO138
Barcode # HO138
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category