The Ohlins ACE shock absorber pair is designed as a direct-fit suspension option for the Honda Monkey. Built for consistent control on the street, it focuses on predictable response and ride quality. This listing is supplied as a matched pair for the rear.

Ohlins | Made to race, perfected to ride

Ohlins street suspension is engineered around damping control and durability, with a focus on repeatable performance over time. The ACE range is intended to balance comfort and stability for everyday riding and spirited use.

Who this shock is for

Suited to Honda Monkey owners who want a more controlled rear end than standard, particularly if you ride varied road surfaces or carry extra load at times. It’s also a sensible choice if you want a quality, serviceable unit rather than a disposable replacement.

Shock design & features

The product name confirms this is a rear shock absorber set, supplied as a pair. Further internal architecture details (such as whether it is emulsion or oil/gas separated) are not provided in the input data for this row.

Tuning controls

Adjustment features are not specified in the provided product data. Refer to the packaging or manufacturer documentation for the exact tuning controls fitted to this model.

Before you install

Confirm fitment for your exact Honda Monkey model and year, and check that all supplied hardware matches your mounting points. After installation, set sag and verify clearance through full suspension travel before regular use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO936
Barcode # HO936
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category