Ohlins ACE rear shocks are a matched pair designed to replace the standard units on Kawasaki Zephyr 400/750 models and related fitments. Built for street use, they focus on consistent damping control and predictable chassis behaviour across everyday road conditions. This listing is for the twin-shock set.

Ohlins | Made to race, perfected to ride

Ohlins road shock absorbers are engineered around controlled damping and repeatable performance. The aim is stable support through corners, improved composure over rough surfaces, and clearer feedback at the tyre contact patch.

Who this shock is for

Suited to riders restoring or upgrading a classic twin-shock Kawasaki and wanting a more controlled, confident ride than tired or under-damped originals. Also a sensible choice if you regularly ride on mixed-quality roads and want improved stability without moving away from a traditional twin-shock layout.

Shock design & features

These are purpose-built rear shock absorbers supplied as a left/right pair for twin-shock applications. The internal architecture (including whether damping is emulsion or oil/gas separated) is not specified in the provided product data.

Tuning controls

Adjustment features are not stated in the supplied product data. If you need confirmation of damping adjusters or spring preload adjustment style, check the exact part number details on the shock body/packaging before purchase or installation.

Before you install

  • Confirm model and year fitment for your Zephyr (and any related models) before fitting.
  • Inspect mounting hardware and bushes; replace worn components to avoid play and premature wear.
  • Set static and rider sag after installation, then reassess balance front-to-rear once bedded in.

Serviceability/lifecycle

Ohlins shocks are designed to be maintained and serviced to keep damping consistent over time. Service intervals depend on use, environment, and storage; for best results, plan periodic inspection for leaks, noise, or degraded control.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA134
Barcode # KA134
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category