The Ohlins DMX1216 TTX Flow DV rear shock is a purpose-built replacement unit for Kawasaki KX 450F applications. It is designed to deliver consistent damping feel and improved control through a gas-pressurised, oil/gas separated architecture. The internal layout uses dedicated circuits to manage wheel movement more predictably across changing track conditions.

Ohlins | Made to race, perfected to ride

Built around Ohlins TTX Flow DV know-how, this rear mono shock focuses on stability, traction and usable feedback. The design targets repeatable performance over long motos by maintaining damping consistency under heat and load.

Shock design & features

  • TTX Flow DV product family rear shock configuration
  • Gas-pressurised, oil/gas separated damping system (not an emulsion design)
  • Developed to improve chassis control and rear-wheel connection on acceleration and braking phases

Tuning controls

This shock includes external compression and rebound damping adjustment, allowing you to balance comfort, traction and support to suit track conditions and riding style. Spring selection is separate, so the unit can be matched to rider weight and intended use.

Before you install

Please note the shock is supplied without a fitted spring (refer to the specified spring series in the product notes). An optional preload adjuster is referenced as compatible in the notes. This model also replaces the earlier DMX 0216 part number.

Serviceability/lifecycle

As an Ohlins race-derived unit, regular servicing and correct oil selection are important to maintain damping accuracy. Follow Ohlins-recommended service intervals and use the specified Ohlins oil listed for this product.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX1216
Model # T46PR1C2W
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 453.0
Type Code T46PR1C2W
Stroke Metal to Metal (mm) 136.0
Product Family TTX Flow DV
Notes 06310- & 06451- spring series. Preload adjuster 15000-02 fits this shock. *Replaces DMX 0216*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category