The Ohlins STX 36 Blackline rear shock pair is designed for Kawasaki ZRX 1100 and ZRX 1200 models, delivering modern damping control in a twin-shock layout. Built around Ohlins street-focused architecture, it targets improved stability and composure without changing the character of the bike. The Blackline finish suits classic and retro-styled machines while keeping the hardware purposeful and service-friendly.

Ohlins | Made to race, perfected to ride

STX is Ohlins’ proven street shock platform, developed to deliver consistent damping and predictable feel across a wide range of riding conditions. In Blackline trim, it pairs a subdued appearance with the same engineering approach used across the Ohlins road range. This kit is supplied as a matched pair for rear twin-shock applications.

Shock design & features

This is an oil/gas separated rear shock design intended to maintain damping consistency during extended road use. The twin-shock format suits the ZRX chassis and preserves the original rear suspension layout while lifting control and compliance. As with Ohlins units, the shocks are built to be serviced and maintained over time.

Tuning controls

Adjustability includes spring preload, rebound damping, and compression damping. These controls allow you to set ride height and support for load changes, then fine-tune how the rear end reacts to bumps, braking forces, and corner exits. Adjustment range is intended to cover typical road riding through to more spirited use.

Is it right for you?

Choose this rear shock pair if you want a quality twin-shock upgrade for a Kawasaki ZRX 1100 or ZRX 1200 with meaningful tuning capability and a darker, understated finish. It suits riders chasing better chassis control and comfort from the rear without moving away from the bike’s classic aesthetic. If you regularly change load (pillion, luggage) or ride varied roads, the available adjustments are particularly useful.

Before you install

Confirm model compatibility for your specific ZRX 1100/ZRX 1200 variant and check overall condition of mounting hardware and linkage points where applicable. After installation, set preload to establish correct stance and then work through rebound and compression adjustments methodically, one change at a time. A post-install fastener check after the first few rides is recommended.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO963
Model # S36PR1C1L (B)
Barcode # HO963
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 365.0 +7/-3
Spring Rate Standard 20.3 - 28.6 N/mm Progressive
Type Code S36PR1C1L (B)
Stroke Metal to Metal (mm) 93.0
Product Family STX 36 Blackline
Fitted Spring 00480-23
Spring Colour Black

More From This Category