The Ohlins STX 36 twin rear shock kit for the Indian Scout and Scout Sixty is built for riders who want a more controlled, composed rear end without compromising ride quality. It uses a pressurised damping design to keep damping consistent as conditions change. This makes it well suited to spirited road riding where traction, stability and chassis balance matter.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control and repeatability. In twin-shock applications, that means predictable behaviour through bumps and during braking and acceleration transitions.

Shock design & features

  • STX 36 twin-shock rear configuration for Indian Scout and Scout Sixty fitment
  • Pressurised damping architecture to help maintain consistent performance
  • Designed to improve rear tyre contact and stability during real-world riding

Tuning controls

This shock set provides external adjustment for rebound damping and compression damping, allowing you to tailor the feel for comfort, grip and chassis control. Adjustments are intended to be used alongside correct springing and sag to achieve a balanced setup.

Base setup (factory preset)

These shocks are supplied with an Ohlins baseline setting from the factory, intended as a starting point for the Scout platform. From there, fine-tuning rebound and compression can help match rider load, road surface and preferred feedback.

Before you install

  • Confirm fitment for your exact model and year of Indian Scout or Scout Sixty before installation
  • After installation, set sag and then adjust damping to suit your riding conditions
  • Check clearance and fastener torque to the motorcycle manufacturer’s recommendations

Serviceability/lifecycle

Ohlins shocks are designed to be serviced and reconditioned to keep performance consistent over time. Periodic servicing helps maintain damping quality and seals, particularly if the bike is used regularly on rough roads or in wet conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU IN524
Model # S36PR1C1L
Barcode # IN524
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 293.0 +6/-4
Spring Rate Standard 41.0 N/mm
Type Code S36PR1C1L
Product Family STX 36 Twin
Fitted Spring 60281-30
Spring Colour Black
Rec. Ohlins Oil 01309-

More From This Category