The Ohlins KA224 STX 36 twin rear shock set is built for the Kawasaki W 650 and focuses on consistent damping control and clear feedback. Using a pressurised gas damping layout, it is intended to maintain stability and traction through a wide range of road conditions. Separate damping circuits allow adjustment to suit rider preference and load.

Ohlins | Made to race, perfected to ride

Ohlins suspension development is driven by repeatable damping behaviour and predictable chassis response. The KA224 continues that approach in a twin-shock format suited to the W 650’s rear suspension design.

Who this shock is for

  • Riders updating tired or inconsistent rear suspension on a Kawasaki W 650
  • Owners wanting improved control and stability without changing the bike’s classic twin-shock layout
  • Riders who value tunability to match different riding styles and loads

Shock design & features

  • STX 36 twin-shock architecture for rear fitment
  • Gas-pressurised damping system to support consistent performance
  • Dedicated damping circuits designed to provide controlled feedback and traction

Tuning controls

  • Compression damping adjustment
  • Rebound damping adjustment

Before you install

  • Confirm correct fitment for Kawasaki W 650 and your specific model year/variant
  • Set sag and damping to suit rider weight, riding style, and typical load
  • Inspect linkage and mounting hardware condition during installation

Serviceability/lifecycle

As with all high-quality dampers, periodic servicing helps maintain damping consistency and seal life. A refresh is recommended when performance changes are noticed or as part of scheduled maintenance for regularly ridden bikes.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA224
Model # S36D
Barcode # KA224
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 325.0
Spring Rate Standard 16.0 - 26.0 N/mm Progressive
Type Code S36D
Stroke Metal to Metal (mm) 93.0
Product Family STX 36 Twin
Fitted Spring 00360-04
Spring Colour Black

More From This Category