The Ohlins KA416 is a rear STX 36 twin shock kit for the Kawasaki ZRX 1200, built around Ohlins race-derived damping architecture for consistent control on the street. It uses a gas-charged, oil/gas separated design to help maintain damping stability as conditions change. Adjustment is provided for rebound damping and compression damping, along with ride height to refine chassis balance.

Ohlins | Made to race, perfected to ride

Ohlins suspension units are engineered to deliver predictable response and clear feedback, with a focus on controlled movement rather than harshness. This twin-shock arrangement is intended to suit classic chassis layouts while bringing modern damping behaviour.

Who this shock is for

  • ZRX 1200 riders who want more composure from the rear under braking and acceleration
  • Owners looking to tune rear grip and stability without changing the character of a twin-shock bike
  • Riders who value adjustability for different roads, loads, and riding pace

Shock design & features

  • STX 36 twin-shock configuration for rear fitment on twin-shock applications
  • Gas-charged, oil/gas separated damping system to help resist fade and keep response consistent
  • Ohlins valving approach aimed at traction and controlled chassis movement

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Ride height adjustment to fine-tune chassis attitude

Before you install

  • Set sag and baseline damping after installation so adjustments are meaningful and repeatable
  • Confirm clearance and alignment on a twin-shock chassis, especially if you adjust ride height
  • After initial rides, re-check fasteners and re-confirm settings once the suspension has bedded in

Serviceability/lifecycle

This is a rebuildable Ohlins unit designed for ongoing servicing. Periodic maintenance helps keep damping consistent and protects internal components over the long term.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA416
Model # S36PR1C1L
Barcode # KA416
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 365.0 +8/-2
Spring Rate Standard 20.3 - 28.6 N/mm Progressive
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Twin
Fitted Spring 00480-23
Spring Colour Black

More From This Category