The Ohlins STX 36 Twin rear shock is built for riders who want more consistent damping control and clearer chassis feedback from their Kawasaki GPZ 600 R. It is designed as a dedicated street-fitment unit with Ohlins valving and springing to suit the application. The focus is stability, traction and predictability across a wide range of real-world riding conditions.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a strong engineering focus on damping control, temperature stability and repeatable performance. The STX 36 Twin family follows this approach with a compact rear-shock architecture intended to deliver confidence and control without compromising day-to-day usability.

Shock design & features

  • STX 36 Twin rear shock design for the GPZ 600 R fitment
  • Gas-pressurised damping system for consistent performance during longer or harder rides
  • Valving aimed at improving traction and composure through acceleration and braking

Tuning controls

This rear shock provides external damping adjustment for both compression and rebound, allowing you to tailor support, grip and ride control to tyres, load and road conditions.

Base setup (factory preset)

The unit is supplied with an Ohlins factory baseline setup intended to be a sensible starting point for the model application. Fine-tuning is typically done after checking sag and confirming the bike’s intended load and riding style.

Before you install

  • Confirm fitment to the Kawasaki GPZ 600 R and check mounting hardware condition before installation
  • Set sag and damping from the supplied baseline once installed
  • Inspect linkages/bushes and ensure the rear end moves freely to get the best from the shock

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA542
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 310.0
Spring Rate Standard 70.0 N/mm
Stroke Metal to Metal (mm) 67.0
Product Family STX 36 Twin
Fitted Spring 01091-19

More From This Category