The Ohlins TR924 STX 36 twin rear shock set is built for the Triumph Speed Twin, delivering controlled damping and consistent chassis behaviour for road use. Based on Ohlins STX architecture, it’s designed to give clear feedback and stable support through changing surfaces. This is a twin-shock rear arrangement for riders who want quality adjustability without overcomplicating the setup.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with an engineering-first approach to damping control and repeatability. The STX 36 twin format is aimed at predictable rear grip and composed handling in real-world riding. It’s a focused upgrade path when you want refinement rather than a dramatic change in feel.

Who this shock is for

  • Triumph Speed Twin owners looking for a higher level of rear-end control and feedback
  • Riders who want a tunable twin-shock setup for everyday road riding and spirited runs
  • Anyone replacing worn or tired OE twin shocks with a serviceable performance unit

Shock design & features

This is a gas-pressurised, oil/gas separated shock design intended to maintain damping consistency as conditions and temperatures change. The TR924 is part of the Ohlins STX 36 Twin family and suits the Speed Twin’s rear twin-shock layout.

Tuning controls

Adjustment is provided for rebound damping and spring preload, allowing you to balance comfort, support and traction to suit rider load and road conditions. This makes it practical to dial-in for solo riding, luggage, or a firmer feel without changing hardware.

Before you install

  • Confirm the application and fitment for your Triumph Speed Twin before installation
  • Set sag and preload correctly before making damping changes
  • After fitting, re-check fasteners and clearances through suspension travel

Serviceability/lifecycle

Ohlins units are designed to be serviced so performance can be maintained over time. Periodic oil and seal service helps keep damping response consistent and protects internal components.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU TR924
Model # S36ER1L
Barcode # TR924
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 384.0 +5/-5
Spring Rate Standard 16.0 - 26.0 N/mm Progressive
Type Code S36ER1L
Stroke Metal to Metal (mm) 102.0
Product Family STX 36 Twin
Fitted Spring 60480-02
Spring Colour Black
Rec. Ohlins Oil 01309-

More From This Category