The Ohlins YA047 rear mono shock is built around Ohlins’ proven STX architecture for road use where stability, grip and damping consistency matter. It is designed to give you a wider, more controlled tuning window than a standard shock while maintaining predictable behaviour across changing road conditions. This unit is supplied with a fitted spring and is intended as a direct-fit rear upgrade for the Yamaha FZR 600.

Ohlins | Made to race, perfected to ride

Ohlins road shocks are developed from racing know-how, then valved and packaged for real-world ride quality and control. The focus is on usable damping support, traction and stability rather than harshness.

Shock design & features

This is a gas-pressurised, oil/gas separated mono shock designed to maintain damping performance during sustained use. The internal layout supports consistent control under load changes such as corner entry, braking and acceleration.

Tuning controls

You can tune rebound damping, compression damping, and spring preload. These adjustments let you balance comfort versus support, manage chassis attitude, and tailor grip and response to rider weight, tyres and riding conditions.

Base setup (factory preset)

The shock is delivered with an Ohlins baseline setting intended to be a safe starting point for typical road use. Fine-tuning is best done one change at a time, prioritising correct ride height and sag before altering damping.

Before you install

Confirm the shock is matched to your exact model and linkage configuration, and set sag with the fitted spring once installed. After installation, check clearance through full suspension travel and re-check fasteners after the first rides.

Serviceability/lifecycle

This Ohlins unit is fully serviceable. Regular oil and seal service helps maintain damping consistency and component life, especially if the bike is used hard or stored for long periods between rides.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA047
Model # S46HCRTA
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 300.0 +12/-0
Spring Rate Standard 130.0 N/mm
Type Code S46HCRTA
Stroke Metal to Metal (mm) 50.0
Product Family STX 36 Twin
Fitted Spring 01093-49

More From This Category