The Ohlins YA206 STX 36 twin rear shock set is built for the Yamaha XS 1100 S, focusing on controlled damping and consistent chassis behaviour. It uses a gas-pressurised design to help maintain damping stability as conditions and load change. The twin-shock layout suits the XS 1100 S rear end while offering a modern, tuneable damping platform.

Ohlins | Made to race, perfected to ride

Developed from Ohlins race-derived suspension know-how, the STX 36 Twin family is intended to deliver predictable feel and stable traction. This unit is aimed at riders who want a more controlled and confidence-inspiring rear end without losing the classic twin-shock architecture.

Who this shock is for

  • XS 1100 S owners restoring, upgrading, or modernising rear suspension control
  • Riders who value consistent damping response for spirited street riding
  • Those wanting adjustability to suit different road conditions and riding pace

Shock design & features

  • Rear twin-shock configuration for Yamaha XS 1100 S fitment
  • Gas-pressurised damping design to support consistent performance
  • STX 36 Twin platform with race-informed internal valving approach

Tuning controls

This shock set provides external damping adjustment for both compression and rebound, allowing you to balance support and comfort to match your tyres, road surface and riding style.

Before you install

  • Confirm overall condition of swingarm bushes, linkage (if applicable), and mounting hardware to get the most from the new shocks
  • Check clearance around exhaust and chain guard areas before final tightening
  • After installation, re-check fastener torque and inspect for any interference through full suspension movement

Serviceability/lifecycle

Ohlins units are designed to be serviced to maintain performance over time. Periodic servicing helps keep damping consistent and extends component life, especially on older platforms where suspension loads and bush wear can vary.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA206
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 326.0
Spring Rate Standard 20.0 - 28.0 N/mm Progressive
Stroke Metal to Metal (mm) 86.0
Product Family STX 36 Twin
Fitted Spring 00480-04

More From This Category