The Ohlins KA336 TTX RT rear shock is a dedicated replacement unit for the Kawasaki ZX-6R, built around Ohlins’ race-derived TTX damping architecture. It’s intended to deliver consistent control through braking, corner entry and drive, with a broad tuning range for different tyres and track conditions. This unit uses a pressurised, oil/gas separated design to maintain damping consistency under sustained load.

Ohlins | Made to race, perfected to ride

TTX technology is developed from competition use, with a focus on stable damping behaviour and clear chassis feedback. The KA336 is designed to suit supersport-style riding where repeatable performance and predictable grip matter most.

Who this shock is for

  • ZX-6R riders doing regular track days or club racing who want more control and adjustability than a standard rear unit
  • Riders looking to tune rear stability under braking and improve drive out of corners
  • Anyone wanting a serviceable, motorsport-grade rear shock as part of a complete suspension setup

Shock design & features

  • TTX RT rear mono shock architecture for consistent damping behaviour
  • Pressurised, oil/gas separated damping system to help reduce fade during hard use
  • Race-developed internal layout aimed at maintaining traction and chassis control

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment
  • Ride height adjustment

Serviceability/lifecycle

As an Ohlins unit, the KA336 is designed to be maintained and re-valved as requirements change. Regular servicing helps keep damping consistent and allows the shock to be tuned around tyre choice, rider load and circuit conditions.

Before you install

  • Confirm fitment for your exact ZX-6R model and year before ordering
  • Set sag and baseline adjustments after installation, then fine-tune damping to suit your riding
  • Check clearance and linkage condition to ensure the rear end can move freely through its travel

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA336
Model # T36PR1C1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 341.0 +2/-4
Spring Rate Standard 95.0 N/mm
Type Code T36PR1C1LS
Stroke Metal to Metal (mm) 64.0
Product Family TTX RT
Notes Repl.by KA 361
Fitted Spring 21040-31

More From This Category