The Ohlins STX 36 Supersport rear shock for Yamaha R15 V4 and R15M is built to deliver controlled damping and consistent chassis support under sporty road and track use. Developed from Ohlins racing architecture, it focuses on stability, grip and clear feedback without compromising reliability. It is a purpose-made rear mono shock intended as a direct-fit replacement.

Ohlins | Made to race, perfected to ride

STX Supersport units are designed around predictable damping response and tuning range suited to lightweight sportbikes. The goal is to provide a calmer, more controlled rear end through braking, turn-in and acceleration, with a stronger connection between tyre load and rider feel.

Who this shock is for

  • Riders chasing more consistent rear grip and stability on an R15 V4 or R15M
  • Track day riders who want a more controlled platform and clearer feedback
  • Owners looking for a quality, serviceable rear shock upgrade over stock

Shock design & features

This is a gas-pressurised, oil/gas separated monotube design intended to maintain damping consistency as temperatures rise. The STX 36 layout supports stable damping behaviour and repeatability under aggressive riding loads.

Tuning controls

External damping adjustment is provided for rebound and compression, allowing you to balance support and grip to suit tyres, track surfaces and riding style. These adjustments are intended to help fine-tune corner exit traction, stability under braking, and overall chassis attitude.

Before you install

  • Confirm fitment for Yamaha R15 V4 and R15M and inspect linkage bearings and mounting hardware condition before installation
  • Set sag and baseline damping after installation to suit rider weight and usage
  • If changing springs or chasing a specific balance, plan a setup session to match front and rear behaviour

Serviceability/lifecycle

Ohlins shocks are designed to be serviced and revalved. Regular oil and seal maintenance helps keep damping consistent and extends component life, especially with frequent track use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA229
Model # S36HR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 265.0
Spring Rate Standard 90.0 N/mm
Type Code S36HR1C1
Stroke Metal to Metal (mm) 50.0
Product Family STX 36 Supersport
Fitted Spring 60282-03
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category